ESTES 1841 – Sizzler Manual

(8-98) PN 82107

@ 1998 Centuri Corp. All rights reserved.

The World Leader in Model Rocketry 1295 H Street, Penrose CO 81240

MIGHTY MITES~ READY TO FLY FLYING MODEL ROCKET INSTRUCTIONS Use these instructions for each of your Mighty Mite "rockets.

1.ROCKET STREAMER 8. Measure 全 (2.5 cm) from the nose

Nos E cone and tie streamer to Shock

ATTACHMENT

一 cord with a double knot.

六 .Pull the nose cone out

of the rocket body.

Typical rocket (your design may vary)

{2.5 cmm)

。 二、 、 2. PREPARE STREAMER FOR FLIGHT IMPORTANT:

Wadding must be in place and slide freeiy

太 . Loosely crumple and insert 1/4 of a square for rocket to work properly! of recovery wadding into rocket body.

B. FOLD STREAMER 、

D. Wrap shock cord loosely around

C_Ho L streamer Insert streamer into rocket.

Streamer shoutd siide easily into body

3 放 tube. 和 优 is Stoo tight, unfold and repack.

AS LA

3.PREPARE ENGINE FOR FLIGHT 上 内, Separate igniter and 。B. Jwist off retainer ring “C. Slide engine into rocket

initer plug. at rear of rocket- body as shown.

WARNING : FLAMMABLE

BEFORE PROCEEDING, READP INSTRUCTIONS AND NAR SAFETY CODE INCLUDED WITH ENGINES,

PREPARE YOUR ENGINE ONLY WHEN YOU ARE

OUTSI

ATTHE LAUNCH SITE PREPARING TO LAUNCH!

fyou do net use your prepared engine, remove the

initer before storing Your engine.

D. Twist retainer ring into E. Hold rocket upside down ”Finsert igniter iocked position to hoid and drop in igniter. lgniter plog. 本 卫 本 engine in place. musttouch propellant. G. pr H， Beod er wires