# A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

ESTES 1807 – Snitch User Manual

Summary

This comprehensive manual provides step-by-step instructions for amateur rocketry enthusiasts looking to launch a model rocket. It covers everything from initial assembly, including landing gear attachment, to crucial engine preparation using recommended Estes components. The guide details safe launch protocols, emphasizing adherence to the NAR Model Rocketry Safety Code and outlining proper countdown procedures and handling safety equipment for a safe and successful flight experience.

📄 Preview PAGE OF 3

Page 1 Text Content

AAA 工 清 Estes Industries 86e Jpra Leaoer 太 Hoae/ Pocketry 1295 H Street

EST 1807

Penrose, CO 81240 USA

1.LANDING GEAR ATTACHMENT

NOTE': Its a good idea to Secure wire with a piece of tape.

POSITION WIRE FORM

SNAP INTO PLACE

UNDERTASS

B. Repeat for other two landing gear wires. 多

2. PREPARE SNITCHYw FOR FLIGHT WARNING:

BEFORE PROCEEDING, READ INSTRUCTIONS AND NAR

SAFETY CODEINCLUDED WITH ENGINES.

| PREPARE YOUR ENGINE ONLY WHEN YOUARE OUTSIDE

和合 盖 PLASTIC RETAINER《名 RING

, ATTHE LAUNCH SITE PREPARING TO LAUNCHI

you do not use your prepared engine, remove the igniler before storing your engine.

8. Siide engine into rocket body as shown.

A.Turn the Snitch TY Upside down so that the Ianding gear is facing down and twist off plastic retainer ring at rear of rocket,

C. Twist plastic retainer ring into Iocked position to hold engine in place.

D. Separate igniter

H. Bend igniter

and igniter plug. F. Insert jgniter plug-.

wires back

as shown.

j E Drop the igniter into the

G. Firmly push igniter

, ”engine nozzje.1gniter

plug all the way in .

musttouch propellant.

NOTE:

LAUNCH SUPPLIES TO PREVENT POTENTIAL INJURY OR DAMAGE, To iaunch your rocket, you wii need the following: USE ONLY RECOMMENDED ENGINESI

*Launch bad (Estes Porta-Pad@

DO NOT SUBSTITUTE ANY OTHER ENGINEI

*。Launch Controlier (Estes Eiectron Beam@) “Recommended Estes Engines: B6-0, C6-0. - Use a B6-0 for your first fight to become familiar with your rocket's 和 light pattern.。

PROJECTED ALTITUDE |

*Igniters and lgniter Plugs (inciuded with all Estes engines) Engine Feet 。 Meters Use only Estes products to launch this rocket,

Page Summary Contents For ESTES 1807 – Snitch User Manual

Page 1 AAA 工 清 Estes Industries 86e Jpra Leaoer 太 Hoae/ Pocketry 1295 H Street EST 1807 Penrose, CO 81240 USA 1.LANDING GEAR ATTACHMENT NOTE': Its a good idea to Secure wire with a piece of tape. POSITION WI...
Page 2 FLIGHT PROFILE TIPS FOR FLYING YOUR ROCKET .Choose alarge field away from poweriines, buildings, talltrees, and low fying aircraft. Try to find a field at least 250 feet {76 meters) square. The larger...
Page 3 8... Attach micro-clips to the igniter wires. Arrange the 5 auwm Start audible countdown. micro-clips so they do not touch each other or the metal blast deflector. 4...3...2..1..…… Attach micro-clips ...

Manual Details

Brand Estes
Pages 3
File Size 9.72 MB
Published June 03, 2026
16 views

Enter the captcha to get the download link:

captcha

Frequently Asked Questions

What is the ideal location for launching the rocket?

Choose a large field, away from power lines and buildings. The area should be at least 250 feet square.

What steps must I take if the igniter misfires or fails to ignite?

Remove the safety key, wait one minute, remove the expended igniter, install a new one, and repeat the launch procedure.

Are there specific engine recommendations for this model rocket?

Yes, recommended Estes engines are B6-0 or C6-0. You must use only Estes products to launch this rocket.