Dell OptiPlex 960 Motherboard Configuration Guide
Summary
This technical sheet covers the system board mode configuration process for Dell OptiPlex 755, 760, and 960 desktop computers. It provides step-by-step instructions for reading the management mode label inside the chassis cover, replacing the system board, disconnecting USB devices and network cables, entering the correct mode number during initialization, and completing the configuration. Designed for IT service technicians and field engineers performing motherboard replacements on these enterprise desktop models.
Page 1 Text Content
Dell™ Opti Plex™ 755, 760, 960 System Board Mode Configuration About Cautions CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.
Introduction This tech sheet covers the configuration process required after installing new system board in your Dell Opti Plex 755, 760, or 960 computer. Follow these instructions carefully to make sure that the computer is configured for the correct management mode. Remove the computer cover to read the label that is attached to the inside of the cover.
chassis cover inside
label
You should see one of the following labels on the inside of the chassis cover:
August 2008
Page Summary Contents For Dell OptiPlex 960 Motherboard Configuration Guide
Manual Details
| Brand | Dell |
|---|---|
| Pages | 10 |
| File Size | 931.31 KB |
| Published | July 01, 2026 |
Enter the captcha to get the download link:
Frequently Asked Questions
What is critical information I need before proceeding with the configuration?
You must note the large mode number present on the label attached to the inside of the chassis cover.
What devices should be disconnected before beginning the system board replacement procedure?
Disconnect all USB mass storage devices, such as hard drives or flash keys, and also disconnect the network cable.
If I choose an incorrect management mode during configuration, what is the consequence?
The computer may not operate correctly, and once the mode is selected, it cannot be changed.
What steps are necessary after initializing the system to complete setup?
After initialization completes, reconnect all USB storage devices and the network cable, and then restart the computer.