Panasonic SA-EN27 SC-EN26 SA-EN25 User Manual

Operating Instructions CD Stereo System Model No. SC-EN27

SC-EN26 SC-EN25

These instructions are applicable to the following systems.

Dear Customer

System SC-EN25 SC-EN26 SC-EN27

Thank you for purchasing this product.

Main unit SA-EN25 SA-EN26 SA-EN27

Before connecting, operating or adjusting this product, please read the

Speakers SB-EN25 SB-EN26 SB-EN25

instructions completely.

SC-EN27 is used in

Please keep this manual for future reference.

the illustrations unless otherwise mentioned.

Troubleshooting guide Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the problem, refer to the “Customer Services Directory” on page 8 if you reside in the U.S.A., or refer to the “Limited Warranty” on page 8 if you reside in Canada.

• The disc isn’t correctly set. A beat sound is heard • The disc is scratched or dirty. (Tracks skipped.) while receiving a radio • Switch the TV off or separate it from the unit.

No play.

• There is moisture on the lens. Wait for about an broadcast.

hour and then try again.

A low hum or noise is • Keep the antenna away from other cables and • You may not be able to play MP3 if you have copied heard during AM cords. a multi-session disc that has no data between broadcasts. • Keep the AM antenna away from the unit.

sessions.

MP3 cannot be read. • The location and orientation of the antenna are

• When creating a multi session disc, it is necessary The picture on the

(SC-EN27) incorrect.

to close the session. television near the set

• The TV antenna wire is too close to the unit.

• The amount of data on the disc is too small. Set the disappears or stripes

Separate the antenna wire of the TV set from the

amount of data to greater than approximately 5 MB. appear on the screen.

unit.

Sound is unfi xed,

• Check that the batteries are inserted correctly. (

reversed or comes • Check the speaker connections. ( page 2) Remote control

page 2)

from one speaker only. doesn’t work.

• Replace the batteries if they are worn.

• Noise may occur when playing MP3 if recording

Display

quality is poor.(SC-EN27) • Keep this unit away from mobile telephones. • You plugged the AC power supply cord in for the fi rst • Turn the volume up. time or there was a power failure recently. Set the

No sound or there is a

• Switch the unit off, determine and correct the cause, time. ( page 5)

lot of noise. – –:– –

then switch the unit on. Causes include shorting of • The total programmed play time is more than 200 the positive and negative speaker wires, straining of minutes. the speakers through excessive volume or power, Tracks can still be programmed and played. and using the unit in a hot environment.

• The number of programmed tracks is limited to 24.

• An AC power supply cord or fl uorescent light is near No further tracks can be programmed.

Humming heard during

the cords. Keep other appliances and cords away

play. • A CD-ROM disc that is not CD-DA or MP3 format is

from this unit’s cords.

NO/MP3 inserted.

It cannot be played.

This product may receive radio interference caused by mobile telephones during

use. • Incorrect operation performed. Read the instructions

ERROR

If such interference is apparent, please increase separation between the and try again.

product and the mobile telephone.

• There is a power supply problem. Consult the

dealer.

Panasonic Consumer Electronics Panasonic Puerto Rico, Inc. Panasonic Canada Inc.

Company, Division of Panasonic Ave. 65 de Infantería, Km. 9.5 PC En

5770 Ambler Drive

Corporation of North America San Gabriel Industrial Park, Carolina,

Mississauga, Ontario

Puerto Rico 00985

One Panasonic Way Secaucus,

www.panasonic.ca

New Jersey 07094 http://www.panasonic.com

RQT8520-P

© 2005 Matsushita Electric Industrial Co., Ltd. M1205KS0 Printed in China

SC-EN25 26 27PPC_4.indd 1 2005-12-12 18:05:42