Roland Juno-DS61 Synthesizer User Manual (English) [Supplementary Manual for Juno-DS Version 1.04]

JUNO-DS Version 1.04 Supplementary Manual JUNO-DS Program Update This explains how to update the JUNO-DS’s system program.

Checking the Version Update Procedure Before you download the system program, check the version of your JUNO-DS. Follow the procedure below to install the program “juno_ds_up.bin” in your

JUNO-DS.

1. Press the [MENU] button.

2. Move the cursor to “SYSTEM,” and press the [ENTER] button. NOTE Never turn off the JUNO-DS’s power while the update is in progress.

3. Move the cursor to “INFORMATION” tab.

Doing so may make the JUNO-DS’s system unable to start up correctly.

1. Copy the update-use file (juno_ds_up.bin ) to the root directory of the USB flash drive.

What You’ll Need for the Update In order to update your JUNO-DS, you’ll need the following items. JUNO-DS itself

juno_ds_up.bin

PC to write the updater to the USB flash drive USB flash drive (the USB flash drive needs to be formatted on a JUNO-DS)

EXPORT

Download the System Program and Uncompress the Compressed File

IMPORT

Download the file named “juno_ds_sys_v104.zip.” It is an archive file in zip format, please double click on the file to expand. After expanding the file, the folder “juno_ds_sys_v104” holding the file “juno_ds_ up.bin” will be appeared.

SONG LIST

ROLAND

Note When Updating We recommend that you save your data to a USB flash drive before you perform the update. If a problem occurs and your data is lost, you will be able to restore the original state by reloading the data you saved.

For details on the procedure, refer to the following sections of the “Saving JUNO-DS’s 2. Make sure the JUNO-DS’s power is switched off, then connect the USB flash Data to USB Flash Drive (BACKUP)” of the Owner’s Manual p. 18. drive to the USB MEMORY port. 3. Hold down the [TAP] button and switch on the power.

Never apply this update data to any product other than the JUNO-DS. This update

4. When the message “start update.” appears, release the [TAP] button.

data may destroy the data or system program of other products.

The update starts. The update process takes several minutes to finish. Be sure never to switch off

Never power-off your JUNO-DS while the update is in progress!

the power before the operation finishes.

If a power failure or similar accident occurs during the update process, the JUNO-DS won’t be able to start up in normal operating mode. This will require servicing, so

When the message “===update finished.===” is displayed, the operation has

you will need to contact Roland service center near you if this occurs.

finished. (It will take about 1 minute to update.)

We regret that we are unable to answer questions regarding the update procedure

5. Switch off the power.

using this system program. Please perform the update responsibly, following the directions given in this document. 6. Detach the USB flash drive, then switch on the power to the unit and verify

that the version has been updated.

© 2015 ROLANND CORPORATION