Page 1
G Series LCD Monitor G274F (3CC2) User Guide
Page 2
Contents Getting Started .............................................................................................................. Package Contents ..................................................
Page 3
Getting Started This chapter provides you with the information on hardware setup procedures. While connecting devices, be careful in holding the devices and use a grounded wrist strap to avoid static ...
Page 4
Installing the Monitor Stand 1. Leave the monitor in its protective foam packaging. Align the stand bracket to the monitor groove. 2. Tighten the stand bracket with screws. 3. Connect the base to the ...
Page 5
Adjusting the Monitor This monitor is designed to maximize your viewing comfort with its adjustment capabilities. Important Avoid touching the display panel when adjusting the monitor. 5Getting Starte...
Page 6
Monitor Overview Getting Started
Page 7
Power LED Lit in white after the monitor is turned on. If no signal input, the LED will turn into orange. Lit in orange when the monitor is in Stand-by mode. Power Button & Navi Key Cable Routing ...
Page 8
Connecting the Monitor to PC 1. Turn off your computer. 2. Connect the video cable from the monitor to your computer. 3. Assemble the monitor power adapter & power cord. (Figure A) 4. Connect the ...
Page 9
OSD Setup This chapter provides you with essential information on OSD Setup. Important All information is subject to change without prior notice. Navi Key The monitor comes with a Navi Key, a multi-di...
Page 10
OSD Menus Important The following settings will be grayed out when HDR signals are received: Night Vision Brightness MPRT Contrast Low Blue Light Color Temperature HDCR Gaming 1st Level Menu 2nd/3rd L...
Page 11
1st Level Menu 2nd/3rd Level Menu Description Response Time Normal Setting to Fastest will reach the shortest response time and help improve blurred images when playing Fastest very fast games. MPRT O...
Page 12
1st Level Menu 2nd/3rd Level Menu Description Adaptive-Sync OFF Adaptive-Sync prevents screen tearing. Activating Adaptive-Sync will affect: Affected Function Function Status MPRT Set to OFF Professio...
Page 13
1st Level Menu 2nd Level Menu Description Image OFF Image Enhancement enhances image Enhancement edges to improve their acutance.Weak Medium Strong Strongest Image 1st Level Menu 2nd/3rd Level Menu De...
Page 14
Auto Scan OFF Users can use the Navi Key to select Input Source at below status: • While “Auto Scan” is set to “OFF” with the monitor at power saving mode; • While “No Signal” message box is shown on ...
Page 15
1st Level Menu 2nd Level Menu Description Transparency 0~5 ∙ Users can adjust Transparency in any mode. OSD Time Out 5~30s Users can adjust OSD Time Out in any mode. Power Button OFF When set to OFF, ...
Page 16
Specifications Monitor G274F Size 27 inch Curvature Flat Panel Type Rapid IPS Resolution 1920 x 1080 (FHD) Aspect Ratio 16:9 Brightness 250 nits (typ.) Contrast Ratio 1000:1 Refresh Rate 180Hz 1ms (GT...
Page 17
Monitor G274F Temperature: 0℃ to 40℃ Operating Humidity: 20% to 90%, non-condensing Environment Altitude: 0 ~ 5000m Temperature: -20℃ to 60℃ Storage Humidity: 10% to 90%, non-condensing * Based on CIE...
Page 18
Preset Display Modes Important All information is subject to change without prior notice. Standard Resolution HDMI™ DP VGA 640x480 @60Hz @67Hz @72Hz @75Hz Dos-Mode 720x480 @60Hz 720x576 @50Hz SVGA 800...
Page 19
Troubleshooting The power LED is off. • Press the monitor power button again. • Check if the monitor power cable is properly connected. No image. • Check if the computer graphics card is properly inst...
Page 20
Safety Instructions Read the safety instructions carefully and thoroughly. All cautions and warnings on the device or User Guide should be noted. Refer servicing to qualified personnel only. Power Mak...
Page 21
California, USA: The button cell battery may contain perchlorate material and requires special handling when recycled or disposed of in California. For further information please visit: https://dtsc.c...
Page 22
TÜV Rheinland Certification TÜV Rheinland Low Blue Light Certification Blue light has been shown to cause eye fatigue and discomfort. MSI now offers monitors with TÜV Rheinland Low Blue Light certific...
Page 23
Regulatory Notices CE Conformity This device complies with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibi...
Page 24
WEEE Statement Under the European Union (“EU”) Directive on Waste Electrical and Electronic Equipment, Directive 2012/19/EU, products of “electrical and electronic equipment” cannot be discarded as mu...
Page 25
Green Product Features Reduced energy consumption during use and stand-by Limited use of substances harmful to the environment and health Easily dismantled and recycled Reduced use of natural resource...