Panasonic SL-MP75 User Manual

Playing MP3

This unit can play MP3 files you have recorded to discs. MPEG Layer-3 audio decoding technology licensed from Fraunhofer IIS and Thomson multimedia.

Dear Customer

SL-MP75 Thank you for Large, two-line display

purchasing this product. This unit can display the MP3 album title, track title and the MP3 ID3 Before connecting, artist name, ID3 track title entered on your computer.

operating or adjusting

Portable CD Player HOLD

this product, please read

This function causes the unit to ignore accidental button presses.

these instructions

Operating Instructions Set to HOLD so the unit doesn’t power on accidentally or play is

completely. Please keep

interrupted.

this manual for future reference.

Note on CD-R and CD-RW

This unit can play CD-R and CD-RW recorded with CD-DA or MP3. Use an audio recording disc for CD-DA and finalize§ it when you finish recording. The unit may not be able to play some discs due to the condition of the recording. §A process performed after recording that enables CD-R/CD-RW players to play audio CD-R and CD-RW.

Resume function

Play begins from the last point stopped. Replacing the disc cancels the function.

Auto off function

If the unit is left in stop mode for approximately 10 minutes, the unit turns itself off automatically.

PC PYP

Panasonic Consumer Electronics Company, Panasonic Sales Company, Division of Matsushita Electric Corporation of America Division of Matsushita Electric of Puerto Rico, Inc. (“PSC”) One Panasonic Way Secaucus, New Jersey 07094 http://www.panasonic.com Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial Park, Carolina, Puerto Rico 00985 Panasonic Canada Inc. 5770 Ambler Drive, Mississauga, Ontario L4W 2T3 www.panasonic.ca

RQT7214-P

C 2003 Matsushita Electric Industrial Co., Ltd.

F1103TT2014

Printed in Japan

Troubleshooting guide Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, see “Product information” on page 3 for assistance.

No play. ≥The HOLD function is on. Release HOLD. (➪page 5) Cannot change the Digital ≥If [:] or [9] is pressed before [$MEMO/%DISP] you ≥The batteries may have run empty (➪page 5). Re-master mode, cannot change the mode.

(If play is extremely short even after fully recharging the anti-skip mode.

batteries, the batteries may have exceeded their life.

Digital Re-master does ≥Depending on the type of MP3 disc recording, the effect may

Rechargeable batteries can be recharged approximately 300

not work. not appear.

times.) ≥The disc isn’t correctly set. Cannot recharge. ≥You aren’t using the special rechargeable batteries (➪page 5). ≥The disc is scratched or dirty. (Tracks skipped.) ≥You must insert two batteries before you can recharge them. ≥There is moisture on the lens. Wait for about an hour and ≥The unit must be off before you can recharge. then try again.

The AC adaptor becomes ≥This is normal.

≥The lens is dirty: clean it with a blower (recommended

warm during recharging.

product: SZZP1038C). If the lens gets marked with fingerprints, gently wipe them off with a cotton swab. The batteries are taking ≥The batteries may take a maximum of 4 hours to recharge ≥The unit may not read MP3 correctly if it is shaken while it is a long time to recharge. under some conditions. reading the files.

Play time is short after ≥This may occur after the first time you recharge the batteries

≥Play of a multi-session disc may not be possible if there is a

recharging. or haven’t used them for a long time. Play time should be

blank data segment between sessions.

restored after a few recharges.

≥If there is large JPEG data etc. within a MP3 file, sound may

≥The batteries can go flat if you leave the AC adaptor

become muted and play may not be possible.

connected after recharging is complete.

≥If you try playing a CD that contains CD-ROM format data and normal audio data (CD-DA), output from one of the above The battery indicator fails ≥The indicator does not appear when the AC adaptor is connected. may become silent, and play may not be possible. to appear or is incorrect. ≥The indicator does not appear correctly under some conditions.

No sound or there is a ≥Ensure the plugs are inserted firmly. The unit stops working. ≥Disconnect then reconnect all power sources (batteries and lot of noise. ≥Wipe the plugs clean with a clean cloth. AC adaptor).

≥Noise may occur when playing MP3 if recording quality is poor. ≥The elapsed playing time disappears and sound is interrupted if bumps continue repeatedly. ≥Separate this unit from mobile telephones.

Displays

Play doesn’t resume ≥This doesn’t work if you change discs. from the last point ≥This doesn’t work during random play.

stopped. ≥It may not work correctly under some conditions.

HOLD ≥The HOLD function is on. Release HOLD. (➪page 5)

Play doesn’t start from ≥Random play modes may be on (➪page 6).

NO DISC ≥You haven’t inserted a disc or it isn’t inserted correctly.

the first track. ≥Play resumes from the last point stopped.

≥You have inserted a disc this unit cannot play.

Cannot search through ≥You cannot search through MP3 files.

OPEN ≥The disc lid is open.

tracks.

CHARGE ≥The batteries are recharging. Recharging is complete when

Cannot skip albums. ≥You cannot skip between the first and last albums during play.

this disappears.

Cannot specify the AB ≥You may not be able to specify segment A or B at the end of

≥The program already contains 20 tracks.

segment. the disc.

READING ≥Reading disc. “ N ” also appears when reading MP3 files.