# A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Home > BT > PHAROS iGPS-BT II User Manual and Instructions

PHAROS iGPS-BT II User Manual and Instructions

Summary

Essential guide for installing and maintaining your iGPS-500 GPS Receiver and Bluetooth Dock. This manual provides comprehensive instructions covering initial setup, Bluetooth pairing process, charging procedures, and troubleshooting steps to ensure secure connectivity with your mobile device or PC. Ideal for users needing a reliable, advanced navigation system that integrates seamlessly with existing technology. Includes details on technical specifications, FCC/CE compliance, and complete warranty information.

📄 Preview 📖 Table of Contents Contents ‹ PAGE OF 16 ›
‹ PHAROS iGPS-BT II User Manual and Instructions - Page 1 ›

Page 1 Text Content

i GPS-BT II User Manual

Page Summary Contents For PHAROS iGPS-BT II User Manual and Instructions

Page 1 i GPS-BT II User Manual
Page 2 FCC Notices This device complies with Part 15(b and c) of the FCC Rules. Operation is subject to the following conditions: • This device may not cause harmful interference. • This device must accept a...
Page 3 I. i GPS-500 Receiver and Bluetooth Dock i GPS-BT II Dock i GPS-500 Receiver DC Jack for charging On/Off Switch Battery charging indicator (Orange/Green LED) Bluetooth Status Indicator (Internal Blue ...
Page 4 II. i GPS-BT II Setup (see walkthrough guides at the end of this section) 1. The i GPS-BT II will need to be charged for two to three hours before initial use. 2. Turn on the i GPS-BT II. The status i...
Page 5 Walkthrough Guides 1. i GPS-BT II Setup for Pocket PCs with built-in Bluetooth Technology running the Windows Mobile Pocket PC OS (the following screen shots show the device as “Pharos i GPS-BT”, it m...
Page 6 5. Provided that your i GPS-BT II is turned 6. Enter the Passkey: 12345678, and on and fully charged, it will be discovered. select “OK” in the upper right-hand Tap on the “Pharos i GPS-BT” icon to co...
Page 7 9.Tap and hold on the “Pharos i GPS- 10. Once the GPS has a connection, the BT: GPS RFcom” icon, select icon will change to Green. You will also “Connect” from the Menu that appears notice that the Bl...
Page 8 13. Now that the COM Port is setup, you 14. Select “YES” to Enable the GPS can Enable the GPS by tapping on the RED Smiley face Bluetooth setup for Windows Mobile 5.0 OS
Page 9 2. i GPS-BT II Setup for Pocket PCs with built-in Bluetooth Technology running the Windows Mobile 5.0 OS (the following screen shots show the device as “Pharos i GPS-BT”, it might be shown as “Pharos ...
Page 10 6. Enter the passkey: 12345678 7. Put a check mark in the box next to “serial port” and tap Finish 8. Next select the “COM Ports” tab at the 9. Select the “Pharos i GPS-BT” and tap, Next. bottom of th...
Page 11 10. Select Com 7, and make sure that there is 11. Close down the Bluetooth Settings screen a check in the “Secure Connection” box and and start the Pharos Ostia navigation program. tap Finish. Start &...
Page 12 14. The Smiley Face should go from Red to Yellow when searching for satellites and finally ….. ….. to Green when a GPS lock for navigation has been established. For Bluetooth setup on other devices, p...
Page 13 Battery Precautions (w: WARNING!) 1.w Reverse charging is not acceptable. 2. Charge before use. The cells/batteries are delivered in an uncharged state. 3.w Do not charge/discharge with more than our ...
Page 14 IV. i GPS-BT II GPS Receiver Specifications Performance Chipset Si RF Star III GSC3f Antenna Integrated patch antenna Frequency L1, 1575.42 MHz Sensitivity -159 d Bm Channels 12 Channel all-in-view tr...
Page 15 V. Precautions • Position fixing may not be available when this receiver is used near high- voltage wire, electronics equipment that generates electrical noise, or mobile phones in operation at 1.5 GH...
Page 16 VIII. Troubleshooting For any troubleshooting assistance, please check the Frequently Asked Questions section at www.pharosgps.com. IX. Warranty The i GPS-BT II Receiver is warranted by Pharos to the ...

Manual Details

Brand BT
Pages 16
File Size 652.97 KB
Published May 17, 2026
101 views

Enter the captcha to get the download link:

captcha

Frequently Asked Questions

What is the initial PIN code needed to connect the iGPS-BT II to my mobile device?

The IMPORTANT PIN Code is 12345678. Please memorize this code for future use.

How long does the iGPS-BT II need to charge before I can use it initially?

It will need to be charged for two to three hours before initial use.

What should I do if my GPS unit experiences radio interference?

You are encouraged to try measures like reorienting or relocating the receiving antenna, increasing separation, or plugging into a different circuit outlet.

Does the iGPS-BT II work well indoors?

No, the text suggests that the device does not work well indoors and requires a direct view to the sky for optimal function.

Related Manuals