Fuji Xerox, FUJIFILM FIJIMVAC Electric Starter BT-50 Manual
Summary
This comprehensive guide provides expert instructions for installing the Fuji-Imvac Electric Starter BT-50 on the associated engine model. The manual details every step, covering required tools, replacement parts lists (including specific part numbers), and crucial safety notes regarding electrical integration, such as BEC usage and noise suppression. It is designed for specialized hobbyists and model aircraft enthusiasts who require detailed guidance to properly install or maintain their Fuji-Imvac BT50SA engine starter system.
Page 1 Text Content
Instructions for the Fuji-Imvac Electric Starter BT-50
Manufactured by FUJI-IMVAC INC. YOKOHAMA, 235-0005 JAPAN
Worldwide Distributor (except Japan): Hobbico®, Inc.
Champaign, IL 61826 USA www.fuji-imvac.com Fuji-Imvac is not related to the original Fuji Engines sold by Mecoa.
INTRODUCTION
These instructions explain the installation of the Electric Starter BT-50 on the Fuji-Imvac BT50SA engine.
Entire Contents © Copyright 2009 FJIZ1150 for FJIG1150 V1.1
Page Summary Contents For Fuji Xerox, FUJIFILM FIJIMVAC Electric Starter BT-50 Manual
Manual Details
| Brand | FujiFilm |
|---|---|
| Pages | 8 |
| File Size | 208.37 KB |
| Published | May 20, 2026 |
Enter the captcha to get the download link:
Frequently Asked Questions
What load does the Blood Eliminator Circuit (BEC) support?
The BEC circuit is rated at 1 Amp and cannot handle more than three regular sized servos.
What minimum battery capacity is needed for installation?
You must use a minimum battery of 6 to 10 cell, 1900mAh.
Why should I suppress the electric noise?
It is required to avoid signal interference from the gas engine on the starter's wiring.
How do I ensure the starter power is off by default?
The remote On/Off switch must be assigned to a spring-loaded transmitter switch for safety reasons.