Dell W-ClearPass 6.1/6.2 Policy Manager Quick Start Guide (Also Applies to Version 6.2) Owner's Manual
Summary
Dell Networking W-ClearPass Policy Manager 6.1 Quick Start Guide (June 2013) covering Policy Manager installation and configuration, server port overview and configuration, useful CLI commands, accessing the interface, basic services verification, and authentication use cases including 802.1x wireless, web-based authentication, and MAC authentication scenarios.
Page 1 Text Content
Dell Networking W-Clear Pass Policy Manager 6.1 Quick Start Guide
Page Summary Contents For Dell W-ClearPass 6.1/6.2 Policy Manager Quick Start Guide (Also Applies to Version 6.2) Owner's Manual
Page 1
Dell Networking W-Clear Pass Policy Manager 6.1 Quick Start Guide
Page 2
Copyright Information Aruba Networks, Inc. Aruba Networks trademarks include the Aruba Networks logo, Aruba Networks®, Aruba Wireless Networks®, the registered Aruba the Mobile Edge Company logo, and ...
Page 3
Contents Configuring Policy Manager Installing Policy Manager Server Port Overview Server Port Configuration Subset of Useful CLI Commands Accessing Policy Manager Accessing Help Checking Basic Servic...
Page 4
Dell Networking W-Clear Pass Policy Manager 6.1 Quick Start Guide
Page 5
Chapter Configuring Policy Manager This Quick Start Guide for the Dell Networking W-Clear Pass Policy Manager System (Policy Manager) describes the steps for installing the appliance using the Command...
Page 6
Required Item Item Information Hostname (Policy Manager server) Management Port IP Address Management Port Subnet Mask Management Port Gateway Data Port IP Address must not be in the same subnet as Da...
Page 7
Enter Secondary DNS: 192.168.5.1 4. Change your password. Use any string of at least six characters: New Password:************ Confirm Password:************ Going forward, you will use this password f...
Page 8
Flag/Parameter Description Network interface type: mgmt or data ip <mgmt|data> <ip address> Server ip address. netmask <netmask address> Netmask address. gateway <gateway address&...
Page 9
Chapter Accessing Policy Manager Use Mozilla Firefox 3.0 (or higher) or Internet Explorer 7.0.5 (or higher) to perform the following steps: 1. Open the administrative interface. Navigate to https://&l...
Page 10
6. Change the password. Navigate to Administration Admin Users, then use the Edit Admin User popup to change the administration password. Accessing Help The Policy Manager User Guide (in PDF format) i...
Page 11
Chapter Checking Basic Services To check the status of service, navigate to Administration Server Manager > Server Configuration, then click on row to select server: The System tab displays server ...
Page 12
Dell Networking W-Clear Pass Policy Manager 6.1 Quick Start Guide
Page 13
Chapter 802.1x Wireless Use Case The basic Policy Manager Use Case configures Policy Manager Service to identify and evaluate an 802.1X request from user logging into Wireless Access Device. The follo...
Page 14
Policy Manager ships with fourteen preconfigured Services. In this Use Case, you select Service that supports 802.1X wireless requests. Table 1: 802.1X Create Service Navigation and Settings Navigatio...
Page 15
Navigation Settings [Guest Device Repository] [Local SQL DB] [Endpoints Repository] [Local SQL DB] [Onboard Devices Repository] [Local SQL DB] [Admin User Repository] [Local SQL DB] Amigo Pod AD [Acti...
Page 16
Table 4: Role Mapping Navigation and Settings Navigation Settings Create the new Role Mapping Policy: Roles (tab) Add New Role Mapping Policy (link) Add new Roles (names only): Policy (tab) Policy Nam...
Page 17
(external), or an Audit Server (internal or external). Each of the first three use cases demonstrates one of these options; here, the Posture Server Policy Manager can be configured for third-party po...
Page 18
Table 6: Enforcement Policy Navigation and Settings Navigation Setting Configure the Enforcement Policy: Enforcement (tab) Enforcement Policy (selector): Role_ Based_Allow_Access_ Policy For instructi...
Page 19
Chapter Web-Based Authentication Use Case This Service supports known Guests with inadequate 802.1X supplicants or posture agents. The following figure illustrates the overall flow of control for this...
Page 20
2. Create Web Auth-based Service. Table 7: Service Navigation and Settings Navigation Settings Create new Service: Services Add Service Name the Service and select pre- configured Service Type: Servic...
Page 21
Table 9: Posture Policy Navigation and Settings Navigation Setting Create Posture Policy: Posture (tab) Enable Validation Check (check box) Add new Internal Policy (link) Name the Posture Policy and s...
Page 22
Navigation Setting When finished working in the Posture Plugin tab click Next to move to the Rules tab) Set rules to correlate validation results with posture tokens: Rules (tab) Add Rule (button open...
Page 23
Table 10: Enforcement Policy Navigation and Settings Navigation Setting Add new Enforcement Policy: Enforcement (tab) Enforcement Policy (selector): SNMP_POLICY Upon completion, click Save. 6. Save th...
Page 24
Dell Networking W-Clear Pass Policy Manager 6.1 Quick Start Guide
Page 25
Chapter MAC Authentication Use Case This Service supports Network Devices, such as printers or handhelds. The following image illustrates the overall flow of control for this Policy Manager Service. I...
Page 26
Configuring the Service Follow these steps to configure Policy Manager for MAC-based Network Device access. 1. Create MAC Authentication Service. Table 11: MAC Authentication Service Navigation and Se...
Page 27
(NESSUS). You can also configure the audit server (NMAP or NESSUS) with post-audit rules that enable Policy Manager to determine client identity. Table 13: Audit Server Navigation and Settings Navigat...
Page 28
Dell Networking W-Clear Pass Policy Manager 6.1 Quick Start Guide
Manual Details
| Brand | Dell |
|---|---|
| Pages | 28 |
| File Size | 1.06 MB |
| Published | July 03, 2026 |
4 views
Enter the captcha to get the download link:
Frequently Asked Questions
How do I initially connect and power on the PolicyManager appliance?
Connect to a terminal using the null modem cable, then apply power and switch it on.
Where should I obtain my IP address for the Data Port?
The API documentation/planning phase is required. The manual notes the Data Port IP must not be in the same subnet as the Management Port IP Address.
What is the default initial login for configuration?
Username: appadmin, Password: eTIPS123.
Does configuring NTP servers provide automatic time syncing?
Yes, you can set it by selecting option 2 and providing Primary/Secondary NTP Servers (e.g., pool.ntp.org).
What is the purpose of the Audit Server configuration?
An Audit Server performs a vulnerability analysis to help determine client identity or roles.