Dell PowerConnect 3524P Release Notes
Summary
Release notes for Dell PowerConnect 3524, 3548, 3524P, and 3548P managed switches, documenting system firmware version 2.0.0.47 (May 2012). Details added functionality including the new service password-recovery command and SNMP Walk ifTable MIB fix for stacking configurations. Lists resolved issues alongside known restrictions and limitations such as auto-negotiation behavior on port channels with fiber ports and voice VLAN considerations.
Page 1 Text Content
Dell™ Power Connect™ 3524/3548/3524P/3548P
Power Connect 3524/3548/3524P/3548P Release Notes
Date: May 2012 System Firmware Version 2.0.0.47
Information in this document is subject to change without notice. © 2011 Dell Inc. All rights reserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo and Power Connect are trademarks of Dell Computer Corporation; Microsoft and Windows are registered trademarks of Microsoft Corporation. Other trademarks and trade names may be used in this document to refer to either the entity claiming the marks and names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names other than its own. All rights reserved. This document may not, in whole or in part, be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine readable form without the prior written consent of Dell. Dell reserves the right to make changes without further notices to any products or specifications referred to herein to improve reliability, functionality or design. Reproduction, adaptation or translation without prior written permission is prohibited, except as allowed under the copyright laws.
Page Summary Contents For Dell PowerConnect 3524P Release Notes
Manual Details
| Brand | Dell |
|---|---|
| Pages | 6 |
| File Size | 168.62 KB |
| Published | June 17, 2026 |
Enter the captcha to get the download link:
Frequently Asked Questions
How must I configure the Login Banner on this device?
The configuration requires using designated CLI commands, as a cut & paste operation is not supported.
What is the maximum capacity for MAC address entries?
The system does not learn the stated maximum of 8K entries; instead, it learns only 7936.
If I remove a port from a VLAN, will it automatically leave an IGMP group?
No. Ports are not removed automatically from an IGMP group simply by removing them from the VLAN.
Will the Voice VLAN activate automatically if the connected port is in an up state?
No; the manual notes that the Voice VLAN will not activate automatically on any port which is in an 'up' state.